Hey Guys! Took up a project as my introduction to myRio and would appreciate a little guidance on how to get started. I have an OpenSprinkler system setup that is automized to water a garden at a certain time everyday. I'd like to integrate a MPS-2 & MPS-6Dielectric Water Potential Sensor that senses humidity levels in the soil, shows the levels on LabView and sends a signal to the OpenSprinkler all done through myRio. If someone has undertaken a similar project or has any knowledge on how I'd be able to do this please share! Thanks

Academic Hardware Products (myDAQ, myRIO)

Integrating OpenSprinkler system and MPS-2 & MPS-6 Sensors to MyRio and LabView

Hey Guys!

Took up a project as my introduction to myRio and would appreciate a little guidance on how to get started.

I have an OpenSprinkler system setup that is automized to water a garden at a certain time everyday. I'd like to integrate a MPS-2 & MPS-6Dielectric Water Potential Sensor that senses humidity levels in the soil, shows the levels on LabView and sends a signal to the OpenSprinkler all done through myRio. If someone has undertaken a similar project or has any knowledge on how I'd be able to do this please share!

Thanks