Soft Requirements for XCP over CANFD other than ECU Toolkit 18.0 or above?

[ymerlo]

Hello, I am trying to establish an XCP connection over CAN FD and I do not have access to some of the properties under the ECU Toolkit such as "mcPropCANIOmode" then "2—mcCANioMode_CAN_FD_BRS". Notice the Enum grayed out.

My current system is as follows:

1. LabVIEW2018 SP1 f3

2. ECU Measurement and Calibration Toolkit 19.0

3. NI-XNET 19.1

4. NI-CAN 18.0

Is there anything else I need in order to have access to these properties?

Thanks in advance.

[kayfh]

Hi,

the CAN FD props should be visible with your software stack. Have you tried starting with a fresh new VI or reinstalling ECU MC toolkit? Is this a VI which was created using an earlier version of ECU MC toolkit or is part of a LV library?

Kay

[ymerlo]

Hello kayfh,

I did try a new VI and nothing. The ECU toolkit (v19) was freshly installed from v15 for the first time to try to solve the issue.

I am not sure what you mean by your last sentence, but basically as it stands now, I have a blank VI and I do not have access to all the property nodes that should be there.

Thanks for the reply.

[ymerlo]

It looks like uninstalling the toolkit and reinstalling it solved the issue. Just strange because there was never any errors during the installation.

Thanks for all the help.