I am a novice Labview user doing some studying while I am laid off. I want to be able to measure analog voltages of approx -30V to 30V at 0HZ to 20MHz. The plan is to use Labview to generate a triggered scope, spectrum analyzer etc (not sure yet).
I have an old signal generator, but it would be nice if the Labview hardware was capable of providing this also. I am looking for a cost effective (OK, cheap) solution.
The Analog discovery 2 seemed overkill. The cDAQ series are a bit pricey, but maybe the right combo wouldn't be to bad.
Any suggestions for hardware?
