Arduino Uno Error 5002

[skippi]

Hello everyone,

There are some discussions about this problem, I have tried them but still error 5002

I'm doing this example https://decibel.ni.com/content/docs/DOC-20044#/ .I try labview+arduino together and then I am going to make my own things.

What I have done:

- Changed Arduino COM11's baud rate to 115200 in Device manager

- Created manually Baud rate (115200) and VISA Resourse (COM11) -constants --> did not help

- I have Labview 2012 (64bit), NI-VISA 5.4

Init.vi Block Diagram. Do I have to add something here?

Have I forget to install something..? I'm little bit frustrated with this

Big thanks for any help!

[Mustafasei]

I have same problem

[Nathan_B.]

1. Many LabVIEW toolkits do not work with 64-bit verisons of LabVIEW.  The 32-bit version is probably the most commonly used version.
2. LIFA is quite old and it deprecated.  It has been replaced by LINX, you should use LINX instead.