Hi,
I have a question concerning the use of an Arduino Uno and LIFA. I seem to be able to get a proper connection between my Arduino Uno and my laptop using a HC-05 Bluetooth module. However, the sampling rate seems to be limited to ~96 Hz. I was wondering if and how I could improve the sampling rate. Is it possible to get the sampling rate up to 2000 Hz?
I have done some searching on the forums and I've stumbled upon changing the prescale factor, however I can't seem to find exactly how and where to change this in LIFA? Changing the baud rate of the HC-05 doesn't seem to have any effect on the sample rate in LabVIEW.
Any suggestions?
I am fairly new to LabVIEW and programming Arduino's, so any help would be greatly appreciated!
Thanks in advance,
Martin 🙂
