8846A Fluke DMM has a proplem with the reading and it shows as bellow

[Gen0Eng]

Voltage DC Open Loop Value
Range	Unite	Reading	Uint
100	mV	OL	mV
1	V	0.128	V
10	V	0.128	V
100	V	4.08	V
1000	V	3.95	V
Current DC Open Loop Value
Range	Unite	Reading	Uint
100	µA	OL	µA
1	mA	0.41	mA
10	mA	OL	mA
100	mA	41.5	mA
400	mA	41.5	mA
1	A	OL	A
3	A	OL	A
10	A	4.22	A
Resistance Short Loop Value
Range	Unite	Reading	Uint
10	Ω	8.08	Ω
100	Ω	40.73	Ω
1	KΩ	0.0406	KΩ
10	KΩ	0.0406	KΩ
100	KΩ	4.04	KΩ
1	MΩ	0.0039	MΩ
10	MΩ	0.039	MΩ
100	MΩ	0.039	MΩ
1	GΩ	0.039	GΩ
The Reaging of the applied  value on the range adds to half the applied value + the readings in the above tabels
For Example at range 10 ohm the value show up 8.08 if we applied 1 ohm it will equal (8.08 + (applied Value /2)) and it shows 8.58 ohm
For Example at range 100 ohm the value show up 40.73 if we applied 100 ohm it will equal (40.73 + (applied Value /2)) and it shows 90.73 ohm
For Example at range 100mA the value show up 41.5 if we applied 10 mA it will equal (41.5 + (applied Value /2)) and it shows 46.5 mA
Voltage AC Open Loop Value
Range	Unite	Reading	Uint
100	mV	7.3	mV
1	V	0.0072	V
10	V	0.0072	V
100	V	0.0475	V
1000	V	0.638	V
Current AC Open Loop Value
Range	Unite	Reading	Uint
100	µA	0.09	µA
1	mA	0.0006	mA
10	mA	0.005	mA
100	mA	0.06	mA
400	mA	0.575	mA
1	A	0.00087	A
3	A	0.0057	A
10	A	0.0062	A

[altenbach]

Since you posted in the LabVIEW forum, we must assume that your question has something to do with LabVIEW. Please explain.

So far, all you show are some big tables. Can you point out what you perceive as problem?

[Gen0Eng]

As I mentioned earlier, the DMM (Digital Multimeter) seems to be showing incorrect readings. Even when no wires are connected to the mA or A jacks, the meter still displays a reading of 4.2 A on the 10A range.

[altenbach]

I still don't see the connection to LabVIEW.

Does Fluke have a support forum?

Looks like a hardware problem or maybe incorrect termination.