Agilent 81110A single pulse

[Cutu]

Hi,

I'm programming an Agilent 81110A pulse generator for singles pulses, using LabVIEW 8.5. I downloaded a collection of VI for this device in NI page. I could set in remote mode a "triggered manual key mode " using the "trigger pulses VI" , but I can't simulate de "man" button like the one on the panel for executing the single pulse.

Thanks!

[Cutu]

Hi,

I'm programming an Agilent 81110A pulse generator for singles pulses, using LabVIEW 8.5. I downloaded a collection of VI for this device in NI page. I could set in remote mode a "triggered manual key mode " using the "trigger pulses VI" , but I can't simulate de "man" button like the one on the panel for executing the single pulse.

Thanks!

[GerdW]

Hi Cutu,

what about reading the manual of your device?

I guess it contains a chapter on programming: just find the command needed to "simulate" that button…

[SKKULAB]

Hi. I also set up a single pulse system nowadays with Labview

I found all the command what I need from 81110a manual, but I am also struggling in executing MAN button by LabVIEW.

If you solve this problem, Could you help me to solve this problem?