BNC 2090A

[meky2007]

Hello Dear. I am new for labview and now I using it. I want to make interface  of functional generator and osciloscope using DAQ 6533 and BNC 2090 A. However , I had faced problems in BNC. I couldn't get  light from LED of the BNC, due to that I couldn't  get any input signal from functional geenrator to BNC. Would you tell me how can I fix it? or Is that BNC doesn't work? 

thanks.

[Dennis_Knutson]

The 6533 is a digital I/O device so your question does not make much sense. There also aren't any LEDs that would indicate the presence of a signal.

[meky2007]

Dear let me explain again, I was connnected the   6533 DAQ card to my laptope   and  BNC board  sing cable to make interface. But  inorder to check  BNC board work properly,the  green  LED (5v) should  display  light , . But for my case it doesn't gives that light.  

[meky2007]

Dear in noraml condition it may seems like below  when it works  it seems the 1st image .

[Dennis_Knutson]

Are you sure the 2090 is compatible with the 6533? Even if it is, it can't be used to measure an output of a function generator.

[meky2007]

Here is my  configuration

[meky2007]

I am not  sure about the compatablity of them. How can I know ?

[Dennis_Knutson]

Check the wiring.

Why are you even persisting with this. You simply cannot create an analog input task with the 6533. I've said this 3 times now.

[meky2007]

Okay  I will  check the wiring. would you look the picture of my configuration. I already uploaded it.

[Dennis_Knutson]

You just don't get it. I'm done with this thread. It's like banging my head against a wall.