Communication Between LabVIEW on Mac and Arduino Uno - USB ports labelled ASRL?::INSTR ?

[gairlochan]

There's only one problem: none of my boards is the right board for the job. The Leonardo clone isn't supported by the LabVIEW Interface for Arduino (at least it's not mentioned …), the Uno clone has USB issues which seem to prevent it from being seen even by the Mac Sys Info or the Arduino IDE atm (intermittently), and my Mega clone (which is installed in one of my robots anyway) is refusing to let me upload the LIFA firmware. Struth! Would you believe it!

Maybe I should take up lion training or something simple and straightforward like that!

I wonder who it is that has put the LIFA package together, and whether they'd have any suggestions.

[johnsold]

Check with the Community pages for Arduino.  I do not participate in that community but it is likely a good resource for you.

It does sound like your problems may be more on the Arduino side than on the Mac/LabVIEW side.

Lynn