Comunication Epos2P and Labview

[Alex25]

Hello,

I'm making a proyect with Epos2P and Labview by USB and i got to connect it with the PC opening:

VCS Open Device Dlg

Select:
-Epos2

-MAXON SERIAL V2
-USB

-USB0

-1000000

-500

getting a "KeyHandle out"

VCS Set Protocol Stack Settings

I write here the "KeyHandle out" i got before

VCS Open Device

I write the same I wrote in the first part and i got other "KeyHandle out"

I do all things just selecting "Run" and not "Run Continuosly"

After I open for example "VCS EXAMPLE_move with velocity" or other (using the same "KeyHandle out") and appear this error -->  Illegal Command (0x0F00FFBF)

And when I try to use "VCS Get Encoder Parameter" appear:

VCS Get Encoder Parameter.vi<ERR>
Maxon Serial V2 Protocol - Bad Data Size received (0x34000004)

I have Labview 2011

Epos2 P 24/5 conected by USB
Motor Maxon DC RE 30 ∅30 mm, Graphite Brushes, 60 Watt

Encoder MR, Type L, 256 - 1024 CPT, 3 Channels, with Line Driver

Thanks

[JB]

I have never use an EPOS2 P driver but the first thing I would do is to check if the driver and LV library are the same than those for EPOS2.

[Alex25]

Thanks JB, my problem was with the library....it was not the correct. It's already working.

[JB]

OK, I'm glad to hear !