LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Connecting LabVIEW and RaspberryPI

I'm trying to connect LabVIEW with RaspberryPI (4 model B).

But I have two problems.

1. Even if you press "upgrate" in "installation" after connecting, nothing is entered in "Installed Version".

    But the log is commented "Target configuration updated".

Installation.png

 

2. Even if you try to run it with the sample Vi, an error will be displayed if it cannot connect to the Raspberry Pi.

 I was able to connect with "Target Configuration". IP address is correct.

Connection error.png

The IP address uses a hotspot on the PC side.
SSH is enabled on the Raspberry Pi side.

 

If anyone have this solution, I would appreciate it if you could contact me.

 

0 Kudos
Message 1 of 4
(1,186 Views)

Hi Tommy,

There should be a log file (in a text file format) when you click on the icon beside the target configuration updated status. Can you pull out the text file and attach it here so the problem can be accurately diagnosed? The issue you are facing is probably LabVIEW was not installed correctly onto your Raspberry Pi.

 

Also when you initiate a connection to the Pi, the icon beside the Raspberry Pi will turn light green instead of dark green, does yours turns light green? (This is in the LabVIEW Example Project Explorer under the Raspberry Pi Target Device).

 

Regards,

Cyongjed 

 

 

36015_Certificate_Badges_FINAL_1_NI_Instructor_v5.jpg

0 Kudos
Message 2 of 4
(1,125 Views)

I wish there was a way I could help you step by step. Have you downloaded  “Raspberry Pi manager” and followed all the instructions before getting to LabVIEW?

Also make sure you download Linx toolkit as well as putty. Putty can be used to connect with raspberry pi remotely.

0 Kudos
Message 3 of 4
(1,102 Views)

@GRCK5000 wrote:

I wish there was a way I could help you step by step. Have you downloaded  “Raspberry Pi manager” and followed all the instructions before getting to LabVIEW?

Also make sure you download Linx toolkit as well as putty. Putty can be used to connect with raspberry pi remotely.


All the screenshots are from LINX/Hobbyist Toolkit, so I don't see this as a problem.  What could be a problem is if you have LabVIEW Community Edition, it comes with the Hobbyist Toolkit, which is literally a re branded (and updated) LINX Toolkit.  I have no idea what happens if you try to install LINX with the Hobbyist Toolkit already installed.  Probably bad things, as you'll most likely have references to both toolkits.  I also have no idea what happens if you have both Community and non-Community flavors of LabVIEW installed side-by-side.  Probably best not to find out.

Bill
CLD
(Mid-Level minion.)
My support system ensures that I don't look totally incompetent.
Proud to say that I've progressed beyond knowing just enough to be dangerous. I now know enough to know that I have no clue about anything at all.
Humble author of the CLAD Nugget.
0 Kudos
Message 4 of 4
(1,093 Views)