Hello all!! I am trying to control the XPS Q8 linear translation stage (300mm) through labview 11. I constructed a VI which communicates my translation stage and moves according to target position which I set. For your reference I have attached my VI. Present VI runs the translation stage towards the target position continuosly. Once it reaches the target position, the program will end. Now I need to modify my VI such that stage should moves towards the target position with some time interval instead of running continously. for example, my target position is to reach 100 mm and I need to stop the stage at every 5 mm for 5 sec. 1 to 5mm with velocity 1 mm/s and stay at 5mm for 5 sec,Again 5 to 10 mm with velocity 1 mm/s and stay at 10 mm for 5 sec.Again 10 to 15 mm with velocity 1mm /s and saty at 15mm for 5 sec.......like this. could you please help to modify my VI.

LabVIEW

Control Newport XPS Q8 linear translation stage

Author

Sir i tried. I got the need. I didnot use get status. Instead i used wait(ms) in the while loop. Thank you very much for your suggestions. I used relative move inside the while loop. I will contact you when i need further clarifications.

Message 11 of 11

(984 Views)

What do you need our team of experts to assist you with?

Request a quote Find the right product Place an order Get support on a product

How can we help?

Please enter your information below and we'll be intouch soon.

This field is required

Preferred communication method

Email Phone call

What do you need our team of experts to assist you with?

Request a quote Find the right product Place an order Get support on a product

LabVIEW

Control Newport XPS Q8 linear translation stage

Re : Control Newport XPS Q8 linear translation stage