DAQmx vi missing

[kdCMC]

Hello,

I've installed labView 2014,2013 & 2012 (32bit) & also v9.9 DAQ driver software & using a laptop, only usb connected to an X series multifunc DAQ device.

I want to view labview 2012 code for NI PCI 6221 card, but some vi's are missing (I also don't see a DAQmx dir in the labview  vi.lib dir).

How can I make these missing vi's available, without having to be connected to the multifunc DAQ device while installing the DAQ driver software?

Missing vi's:

DAQmx Fill In Error Info.vi

DAQmx Clear Task.vi

DAQmx Create Channel (DO - Digital Output).vi

DAQmx Create Virtual Channel.vi

DAQmx Write (Digital 1D Bool 1 Chan 1 Samp).vi

DAQmx Write.vi

regards & thx in advance

[crossrulz · Accepted solution]

First of all, to use DAQmx with LabVIEW 2014, you need to install DAQmx 14.  Also make sure you install DAQmx AFTER you install LabVIEW.

[Yamaeda]

As Rulez point out, Daqmx updates existing LV's at the time of installation, thus it must be installed last. Been there, done that. 😊
/Y

[kdCMC]

which DAQmx version have I to install for 2012?

[Yamaeda · Accepted solution]

Daq14 will support all lower versions (of the ones you have)

/Y