Driver for KST-101 "K-Cube" motor controller for LabVIEW

[Underoos!]

I just replaced my obselete ZST001 motor/stepper controller with a more recent KST101 motor controller however, the labVIEW program does not recognize the motor controller as the driver I think is specific to ZST101 motor controller. I was wondering if someone could help me with the KST101 driver for the labVIEW Program or help walk me through how to draft one up.

PLEASE, ALL AND ANY INPUT OR ADVICE WILL BE GREATLY APPRECIATED 🙂

~ Underoos!

[Bob_Schor]

ThorLabs has two packages for the K-Cube, both of which appear to have LabVIEW "hooks".  Have you examined them?

Bob Schor

[RichieTheBard]

It would seem like you can use the following software package, which should provide ActiveX functions to actually interact with this device, at least according to the documentation of the KST-101 at least.

https://www.thorlabs.com/software_pages/ViewSoftwarePage.cfm?Code=Motion_Control

[diedas]

See my post: https://forums.ni.com/t5/LabVIEW/Thorlabs-KDC101-Communication/m-p/4233099/highlight/true#M1229557