Error -61046 Using When Compiling FPGA Code That Uses External Clock

[lucky_1]

Hello Sir, i'm beginner of labview. 

i'm using PXIE-7820R. 

i want to receive an external clock signal( 10MHz /1pps) from  clock generator. 

So i connect  PXIE-7820R connector pin( external output) with generator. 

and also i  used   External clock example in NI., 

But it is not working... with Error -61046. 

i submit example vi that i used. 

Thank you sir!

[ZYOng]

Are you working on the same project with Michol? A similar question has been asked in Re: PXIe-7820r, Octoclock External clock 10MHz Synchronization