Hi all, I have to use a vi (using an FPGA interface in in its inpouts), in an other Vi (which call directly FPGA Dynamic ( when i opened FPGA reference and configure with an FPGA vi or a bitfile the FPAGA interface take dynamic by default) but i cannot connect the two vi by they FPGA references (plz see picture). did anyone had had this problem before and what is the solution for that? Regards, SASA

LabVIEW

@SASA1 wrote:

but i saw in the link that its a help page for LV 2014. is it working for LV 2013 i'm using ?

You have 2013 installed. Why not just check the help there, rather than asking here on the forum? But, since you asked, here's exactly the same help file from 2013: http://zone.ni.com/reference/en-XX/help/371599J-01/lvfpgahosthelp/fpga_dynamic_host_interface/