Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

How to find the natural frequencies of a steel impactor?

How to find the natural frequencies of a steel impactor?

‎10-25-2016 08:11 AM

Hi guys,

 

I would like to find the natural frequencies of the impactor made of steel. An accelerometer is mounted to the side as i cannot place it to the top (middle). I plan to tap the impactor at the impact point (bottom radius) using an impact hammer.

 

How shall I stabilize the impactor? Shall the impactor be turned 180 degrees and sit on a foam or something?

 

Thank you.

 

IMPACT HAMM.JPG

0 Kudos
Message 1 of 2
(2,716 Views)
Reply

Re: How to find the natural frequencies of a steel impactor?

‎10-25-2016 11:27 AM

How is this a LabVIEW question?

Bill
CLD
(Mid-Level minion.)
My support system ensures that I don't look totally incompetent.
Proud to say that I've progressed beyond knowing just enough to be dangerous. I now know enough to know that I have no clue about anything at all.
Humble author of the CLAD Nugget.
0 Kudos
Message 2 of 2
(2,682 Views)
Reply