!!!Memory Leak Error - Help Urgent!!!

[P@Anand]

I am trying to save a cluster in RT code but when I try to do it am getting "Not enough Memory to perform the Operation" and a message follows it (shown below). Is it due to loading more number of controls in the front panel or it is due to some other reason.

Thanks

[smercurio_fc]

Your issues always seem to be !!!URGENT!!!

From How To Ask Questions The Smart Way :

Don't flag your question as Urgent, even if it is for you

That's your problem, not ours. Claiming urgency is very likely to be counter-productive: most hackers will simply delete such messages as rude and selfish attempts to elicit immediate and special attention.

[P@Anand]

Yes.. Only when it is urgent and no other way to go I use that tag otherwise I'll spend time and debugg the error myself. Ok I abide to your suggestion. Still am searching for the solution.

Thanks

[Yamaeda]

I would assume it's the first part of the error message, an error in the parameters.

/Y

[P@Anand]

What is meant here as "FP.heap"?. I have a very big cluster is it means that?

[smercurio_fc · Accepted solution]

Search is a wonderful tool

http://forums.ni.com/t5/LabVIEW/labview-2009-save-error-code-3-FP-heap/td-p/980474

http://forums.ni.com/t5/LabVIEW/Lavbiew-Save-Error-code-3-FP-heap/td-p/1507982

http://forums.ni.com/t5/LabVIEW/save-error-code-3-FP-heap/td-p/509518

[P@Anand]

Thanks mercurio I didn't use the fp.heap while searching.