04-24-2013 09:49 AM
I have LabView 2012 and MS Office 2007 and I have the exact same problem as you do. I think I found the culprit and fixed it. I rewrote that VI for my application. It's a sub vi of the vi you have in your picture. It's in the NI "Word_Update_Table.VI". If you tell it to move down 60 counts it will only move down 33 counts (Why? I don't have a clue). I fixed it by sticking it in while loop and reading the MoveDown value subtracting it from the intended move down counts until it hits zero.
This is what I did to fix it.
04-24-2013 10:12 AM
Rich - two things I see that can be removed:
04-24-2013 02:48 PM
Eric,
I didn't write this. It's the VI in the NI Report Generation ToolKit. I was just pointing to the problem and I re-wrote this entire VI for my purposes so I didn;t post it.
I think think the reason for the flat sequence is to wait for the information to be on the clipboard. The wire that goes to the flat sequence, but does not go anywhere, ensures the PASTE will not execute until after the information has been pasted to the clip board using that green VI that says Set CB. It's a locked VI so I don't know what it does.
I did notice I made a mistake in what I did post, I forgot to exit the loop on an error.
04-24-2013 02:49 PM
Eric,
I didn't write this. It's the VI in the NI Report Generation ToolKit. I was just pointing to the problem and I re-wrote this entire VI for my purposes so I didn;t post it.
I think think the reason for the flat sequence is to wait for the information to be on the clipboard. The wire that goes to the flat sequence, but does not go anywhere, ensures the PASTE will not execute until after the information has been pasted to the clip board using that green VI that says Set CB. It's a locked VI so I don't know what it does.
I did notice I made a mistake in what I did post, I forgot to exit the loop on an error.
04-24-2013 02:55 PM
Gotcha. I thought that the first image was your code and not the WordUpdateTable VI.
05-10-2013 05:26 AM - edited 05-10-2013 05:27 AM
Super! problem solved! thanks a WHOOOOLE lot M_Berggren, I was struggling with this problem!
(solution I'm talking about: http://forums.ni.com/t5/LabVIEW/Problem-with-append-table-and-Word-2010/m-p/2190960#M702610)