I am using AX5000 AURORA SERIES RF Generator. I want to control my device using serial commands. The serial connector is a DB9 female located on the rear panel of the generator. Serial control and status signals are available at this connector for operation of the generator. The generator responds to input from this connector when the generator ‘Settings’ are set to ‘Serial’. Serial Commands - All serial commands must be terminated with an "ENTER" key. This key is the ASCII character code for Carriage Return. It is a decimal value "13", or and 8-bit value of "00001101". I am attaching the serial command list. All the serial command are terminated with enter key. No serial command (SCPI) is terminated by question mark as you see the screenshot of command list. Please help me in making VI in LabVIEW for control and statue command. Also please tell me the operation sequence of the command which are useful for my operations.

LabVIEW

Author

i have developed an RF power supply interlock but i am facing error.

I want to make an RF interlock based on temperature signal and online Reflection coefficient (RC) measurement.

I have drawn the schematic for the required implementation in LabVIEW. please help me in implementing the part after RF ON/OFF.

how to implement RC <10% and keep RF ON for 1 min i.e. for pulse operation and then switch RF OFF.

In 2nd case if RC>10% Then immediately switch OFF RF ON/OFF switch.

PLEASE HELP ME WITH THE LOGIC TO IMPLEMENT THE CODE.

THANKS

Message 21 of 21

(80 Views)

What do you need our team of experts to assist you with?

How can we help?

Please enter your information below and we'll be intouch soon.

This field is required

Preferred communication method

Email Phone call

What do you need our team of experts to assist you with?