Hi,
I am designing a system consisting an FPGA based board (NEXYS4 DDR) which read a high speed ADC via paralel interface. Now I've programmed the FPGA to take 1000 samples and send it to a LabVIEW GUI when is asked by GUI via UART. Each data sample contents 2 bytes so in the final will be 2000 bytes on UART.
At this moment I don't have a separation syntax between samples (at each 2 bytes), do I need one? So when I hit the acquisition the LabVIEW it will display me the samples without separation between them.
How is the best way to to? To do a separation in FPGA firmware at each sample transmision, or to work with data in LabVIEW and make a syntax with a stacked sequence which will allow me to read 2 bytes and increment an index which will allow me to go to the next 2 bytes.
I hope I was clear where I have my doubts.
At this message you will found an print screen which show you how data looks when I receive from FPGA. In this print screen the indicator are set to show hex display and codes display and 028E is the sample value.
Thank you in advance,
Vlad
