I want to save a waveform that I acquire through my hardware and display it on a sweep chart. Its a time based voltage acquisition. I tried using write to spread sheet or save waveform options in LabVIEW 2009. But when I tried to read it, it only shows me 1 cycle of data(I will be suing a graph here because I want to add cursors to it). I want the exact same whole waveform to be displayed on a graph as I had acquired it. I want to avoid using express vi's since I will be acquiring 10 channels simultaneously so I dont want to slow down the execution speed. I am attaching the base vi that i made to read and write the waveform to a file(I am using simulate signal in this attached vi just to simulate a square wave and check my logic functionality). Can anyone help, please! Thanks in advance.

LabVIEW

It is also silly to read the file over and over again in a while loop.

Message 11 of 11

(173 Views)

What do you need our team of experts to assist you with?

How can we help?

Please enter your information below and we'll be intouch soon.

This field is required

Preferred communication method

Email Phone call

What do you need our team of experts to assist you with?