@Fai0062 wrote:
I also installed the IVI driver for this model but could not configure it in the Labview.
I you are having trouble with drivers you can use NI VISA (in LabVIEW) and use SCPI commands to interface with the power supply. The doc on how to do that is here:
https://siglentna.com/wp-content/uploads/dlm_uploads/2022/06/SPS5000X_Usermanual_E02B.pdf
From that doc:
Users can realize remote control of the instrument by using NI-VISA of NI (National
Instrument Corporation). Regarding NI-VISA, there is a complete and real-time version
(Run-Time Engine version). The complete version includes NI device drivers and a tool
called NI MAX. NI MAX is a user interface used to control the device. The real-time version
is much smaller than the full version, and it only includes NI device drivers.
After installing NI-VISA, use a USB cable to connect the SPS5000X (via the USB Device
interface on the rear panel) to the computer, or use a network cable to connect the
SPS5000X (via the LAN interface on the rear panel) to the local area network where the
computer is located.
Based on NI-VISA, users can remotely control SPS5000X in two ways, one is through web
service; the other is custom programming combined with SCPI commands. For more
information, please refer to the programming examples.
Programing guide follows...
______________________________________________________________
Have a pleasant day and be sure to learn Python for success and prosperity.
