09-20-2024 04:22 PM - edited 09-20-2024 04:24 PM
My specifics
Windows 10 Enterprise
Labview 2022 Q3
I have a TestExec build .exe that uses TestStand and Labvew parts in a custom Operator Interface that is running fine, mostly.
I built all of this with teststand configured in developer mode.
I did a mass compile with no problems and built my lvproj again with no errors.
BUT
I keep getting these windows with a bazillion "Loading" messages while the program is running. How do I turn those "Loading" messages off?, or get all the loads to be done up-front instead of along the way? If that is what is happening.
Any clues appreciated!
Be well,
DLC
09-20-2024 06:20 PM
It's been a while since I used TestStand but I remember there being settings that control whether files needed to run steps are preloaded, or only loaded at run time.
This is the only page online I could find referencing it:
Have you looked into those settings at all? I haven't used TestStand in 5ish years, so any specifics beyond that escape me at the moment...