UDS using CAN Diagnostic Frame Recv.vi Error

[Saurabh_Parmar]

Hello Experts,

I am using ADCS toolkit for UDS using CAN protocol.

Where I want check service x10(Diagnostics session control), for that ADCS toolkit has 'Diagnostic Service.vi'.

Before that I have configured all input parameter setting using below VI., where I provided Transmit ID as well as Receive ID too.

after that Frame is successfully sent to ECU (I checked in using XNET bus monitor), but I am not getting its (Positive or Negative) response from ECU.

I am getting  -8260 Error code which meaning is 'Automotive Diagnostic Command Set: Diagnostic command timeout. A response from the ECU was not received'.

I changed given timeout but still facing same error.

If anyone knows how to solve this, it will be really helpful to me.

Your help would be much appreciated.

Thanks

 

[ZYOng]

This question is best to be posted on the Automotive and Embedded Networks board

Did you see any response frame from the ECU on the Bus Monitor?