converting 1d array to image

[Coq_Rouge]

I hope the txt I received was saved just so I could get the data. Because it take some time to read it, and if speed is an issue ;). But anyway the conversion is simple and quick.

Good luck 

[siju]

Thanks the help ,, your support has been of tremendous help.....

But the image obtained is still monochrome ....am not able to get the color picture...

regards

Rahul

[Coq_Rouge]

The image is gray because I used a grayscale color table. Change the colortable and you will se colors

[siju]

I am not able to use the color tables to create the original color of the image and how do i get the color table of my picture..

pls reply

[siju]

The Reshape array function of converting 1d array pixel information (1228800 elements) to 2d is working fine ,but the conversion time is 350ms while the desired value is around 30ms . so suuggest a way to reduce the conversion time.

pls reply

[Coq_Rouge]

I do not think it is the "Reshape array" function is the problem. On my computer I run this 100 times and it took 250 ms. If I skipped the indicator it took 98ms. Try to remove all indicators not strictly needed it may help.

Message Edited by Coq rouge on 05-05-2009 02:39 PM

[siju]

I am grabbing the image parallely on an activex controller,, Could that be a problem??

there are no other indicators..

Message Edited by siju on 05-05-2009 08:05 AM

[Coq_Rouge]

Oh yes, and certainly if your image indicator is full scale(1280*960).

Message Edited by Coq rouge on 05-05-2009 03:21 PM

[siju]

Anyways, Could u suggest an alternative?

[Coq_Rouge]

---

siju wrote:
Anyways, Could u suggest an alternative?

---

Sorry I do not have any clue, and besides I have never used VISION. But you could perhaps start new thread and ask for code optimazion help in your project