eurotherm rs232

[new_ingenieur]

Hi mike,

In the NI website there are not a 2704 drivers. Only 24XX drivers

http://www.eurotherm.com/labview/

[mikeporter · Accepted solution]

Give then a try, the low-level IO at least should work for you. Naturally, if there are higher-level VIs that refer to attributes that are specific to a particular model they won't be useful.

Mike...

[new_ingenieur]

ok thank you very much, tomorrow I 'would try to do it

[billko]

---

@Dennis_Knutson wrote:
No, it's not universal at all. It is a requirement for GPIB instruments.

---

It's easy to get acronyms confused.  You meant it was a SCPI command.

[billko]

I think I'm wrong, too.  I think it goes back even forther than SCPI, but I forget what it's called.

[Dennis_Knutson]

iEEE-488.2

[billko]

---

@Dennis_Knutson wrote:
iEEE-488.2

---

And since that is the GPIB standard, it turns out that you were right and I was wrong after all.

[mikeporter]

Yes, it existed in varying forms before SCPI. Then it was just one of the commands that HP used with their equipment. It was part of what HP brought to the party when SCPI was formalized. As I recall the two big contributors were HP and Tek.

Mike...

[billko]

Oh, and thanks for being so gracious and letting me down so gently.  😉

[new_ingenieur]

Thanks  i resolved the problem by using 32XX series drivers download in NI site