LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

lv 8.6 Locked (No Password)

LabVIEW 8.6 VI Protection option Locked (No Password) is not being saved.

I also tried saving through Invoke Node, and it didn't work. :smileysad:

 

Is there any work around?

 

Thanks, 

Message 1 of 6
(3,358 Views)

Yes, looks like you found a bug.

 

As an alternative, maybe it is sufficient to set the VI to run mode (ctrl+m).

Message 2 of 6
(3,324 Views)

This certainly does look like a bug in 8.6  This was reported to R&D (# 128657) for further investigation.  Unfortunately this is something we may just have to deal with, pending a fix, so take a look at altenbach's suggestion which may suffice as a workaround.

 

Cheers, 

Brian A.
National Instruments
Applications Engineer
Message 3 of 6
(3,282 Views)

Hi there

 

I ported from 8.5.1 to 8.6.1. All VIs in the project are password protected. Some of them are opened in Run Mode, some in Edit Mode. The option "Environment->Open VIs in Run Mode" shows no effect, neither FALSE nor TRUE.

 

<edit>

When i open the BD of a VI that was opened in Run Mode and switch back to the FP the VI is then in Edit mode. This is extremly annoying.

</edit>

Message Edited by chrisger on 06-25-2009 01:04 AM
Best regards
chris

CL(A)Dly bending G-Force with LabVIEW

famous last words: "oh my god, it is full of stars!"
0 Kudos
Message 4 of 6
(3,017 Views)
If you press CTRL-M like altenback mentioned, does it go back to run mode?
0 Kudos
Message 5 of 6
(2,996 Views)
Yes. The funny thing is: The VI behaves like it's in Run-Mode, e.g. the text settings are invisible etc., but the menu says "Change to Run-Mode" (NOT "Change to Edit Mode"). When i press CTRL-M the VI behaves like in Edit-Mode and the menu still reads "Change to Run-Mode".

Same with CTR-E (like stated above)
Best regards
chris

CL(A)Dly bending G-Force with LabVIEW

famous last words: "oh my god, it is full of stars!"
0 Kudos
Message 6 of 6
(2,972 Views)