myRIO not appearing in "Remote Systems" in MAX

[stefan_keet@live.nl]

Hello,

I was trying to configure the myRIO to Wi-Fi when I found out that the device was not recognized in the remote systems part of MAX. The device works fine when using real-time and FPGA, only this part is not working. When I try to "troubleshooting remote system discovery" the device is also not found when I’m arriving at the "searching for remote system step and an error will pup up:

Error 1 occurred at Release Queue in Discovery Wizard.lvlibp:Find Targets - Get Target Details.vi->Discovery Wizard.lvlibp:Find Targets.vi->Wizard Framework.lvclass:Run Page.vi->Wizard Framework.lvclass : Page Engine.vi->Discovery Wizard.vi 

Could someone give me some advise?

Kind regards

Stefan Ketelaars

[Bob_Schor · Accepted solution]

1. Have you ever connected to this myRIO?  
2. Are you trying to connect via USB or WiFi?
3. If WiFi, is your PC's WiFi "on"?

Bob Schor

[stefan_keet@live.nl]

Thanks for the response,

It was a very basic mistake the wifi from my laptop was turned off.

thanks for the help!

Kind regards

Stefan