programming Hx711 with labview and MyRio

[Joseantoniodemiguel]

Hello.

I need help programming a labview code to read form a HX711 connected to a load cell. I have seen a lot of examples of people using arduino as a DAQ system and labview just to see results but my project is using MyRio as only DAQ system. any solutions?

thank you in advance.

[Jay14159265]

---

@Joseantoniodemiguel wrote:

Hello.

I need help programming a labview code to read form a HX711 connected to a load cell. I have seen a lot of examples of people using arduino as a DAQ system and labview just to see results but my project is using MyRio as only DAQ system. any solutions?

thank you in advance.

---

Here is great place to start:

https://education.ni.com/teach/resources/92/ni-myrio-project-essentials-guide

[Bob_Schor]

Do you have any experience using myRIO?  It is a great little piece of hardware, but the software/hardware interaction can be a little tricky.

• You must be running a compatible version of LabVIEW.  I'm not 100% certain, but I think you might need to be running 32-bit LabVIEW.  I know it runs with LabVIEW 2017, 2019, and 2021, but not very well with 2020.
• You need a "matched" version of the myRIO Software Toolkit.  [There is no 2020 version, for example].
• Have you been able to attach the myRIO (via its USB cable) to your LabVIEW PC and have it show up in MAX under "Remote Systems"?

Bob Schor

P.S. -- I thought I remembered posting a longer response yesterday evening -- maybe I was dreaming ...