Hello! I am having trouble writing the time difference between my set of six swiches to a spreadsheet. I would like only six values to appear on the spreadsheet, the differences between the start and stop of each respective set of switches. I have tried what I normally do when I write to a spreadsheet but was running into issues... Thanks for your help!

OK, so I think I have a better feel for this. Essentially, you have 6 switches; the switches will be toggled once to true (apparently with no clear pattern); when the switch is toggled, no further action can be performed on it; finally, when all switches are toggled to true, the VI completes and the task clears. This is the expected operation no? Try this below. (for the sake of simplicity, I use only one set of channels) Cheers, m

LabVIEW

write time difference to spreadsheet

Solved!

Author

Thank you very much for your help!

Message 11 of 12

(521 Views)

Thank you so much... I was having the worst time trying to time stamp every data point for a continues signal with reference to my time wait command. Until i found this discussion. THANK YOU. Now my speed/current controller thesis is almost done.