DAQ 6353 on linux

[cristianhb]

Hello,

I'm new to National Instruments products. We have a NI PCIe-6353 X Series Data Acquisition board, and would be of our interest to use it under linux.

Is it possible, or they are incompatible?

Best regards.

[bpracek]

Hi!!!

You are using a X Series board, which uses the DAQmx driver.

On the links below you'll find helpful information:

Technical Assistance for Linux and National Instruments Products

http://www.ni.com/white-paper/11803/en#1

NI-DAQmx and NI-DAQ Driver Support: Main Page

http://www.ni.com/white-paper/6909/en

NI-DAQmx for Linux Frequently Asked Questions

http://www.ni.com/white-paper/3695/en#toc2

NI-DAQmx and NI-DAQ Driver Support: PCI/PXI Devices

http://www.ni.com/white-paper/6910/en#xseries

Programming Data Acquisition for Linux with NI-DAQmx Base

http://www.ni.com/white-paper/3838/en

NI-DAQmx for Linux®

http://sine.ni.com/nips/cds/view/p/lang/en/nid/202381

Regards,

[cristianhb]

Thank you very much Barbara, I wonder how I missed those pages.

Best regards.

[cristianhb]

Hello again, I've another question, about this board.

Is it possible to install one board PCIe 6353, and another equal (or very similar) on the same computer?

I need 8 analog outputs (the 6353 has only 4), so with another board, of 4 analog output, I can solve my problem, if they work together without problem in the same motherboard...is it possible to do?

Best regards!

[bpracek]

Hey! 

That's no problem you can use two equal boards on the same PC. 
They are indentified by the serial number, therefore there is no possibility to any type of conflict.

Regards,

[bobjones83]

http://www.ni.com/white-paper/6910/en/

According to that page, the 6353 is not supported on Linux, unfortunately.