Error-1074001424

[xr1200]

While running Cal Exec on an NI-9205 A/D convertor, (Dsub) I get this error message when the Cal/Exec starts the adjust portion of the test.   Error-1074001424 occurred at cex_FL5XMCal_ConfigCalibrator outputAndWait.vi at step adjust. Any help?

[amezam · Accepted solution]

Hello xr1200,

If you’re using a Fluke 5700 Series 1, you could try the next alternatives:

-          Use a Fluke 5700 Series 2.

-          Keep clicking over Retry in the error window, eventually the calibration will complete.

-          If you’re using a PCI-GPIB, try using a USB-GPIB.

If you’re not using it, please describe me your setup. Have a good day!

[xr1200]

Thanks so much for the help.

I will try all your suggestions

Thanks   XR1200