Hi my name is Brandon and I am new to Lab View and DAQ.
I am using Lab View and Advantech (USB 4716) in my experiment. The objective of my experiment is to control the water level in coupled tanks.
I successfully built the block diagram of my system (Coupled tanks + controller) in Lab View.
When I activate the simulation, there is response on the front panel but the hardware do not show any response at all. I am clueless about this and don’t know which direction should I head on to solve this issue.
Hence I am posting this question and I hope I can get some guidance on this.
The attachments below are my system.
Thanks
