Home Community Discussion Forums Most Active Hardware Boards Multifunction DAQ Topic

Multifunction DAQ

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

NI 9381 sine wave generation using FPGA and oscilloscope

NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 09:44 AM

hello I am trying to Generate a sine wave and send it to the output pin of NI 9381 Multifuction I/O..

 

The generation of sine wave is perfec but I could not read it on oscilloscope properly.... I dont know the reason....

 

 

I have attached the VI .....in that VI block diagram the signal value is in I16 variable and output to module4 AO7.......

0 Kudos
Message 1 of 3
(3,380 Views)
Reply

Re: NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 10:42 AM

What are your oscilloscope settings?  Timebase? Channel Impedence?  Channel voltage range?

GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
Message 2 of 3
(3,375 Views)
Reply

Re: NI 9381 sine wave generation using FPGA and oscilloscope

‎05-19-2016 01:44 PM

Everything is correct that side.... Actually my college is doing oscilloscope settings and he is expert in taht.... so no worries....

0 Kudos
Message 3 of 3
(3,370 Views)
Reply