I am updating a large legacy system. I have 16 SCXI-1102 TC modules, and have noticed the ones in the SCXI-1001 chassis are not working properly, whereas the ones in the SCXI-1000 chassis are working. I have swapped modules between chassis and the error stays with the chassis. Also, since the SCXI-1000 is daisy chained through the SCXI-1001 I doubt it is a cabling or controller issue. Because my system is large, is it possible I have a device conflict occuring somewhere? Due to the massive amounts of cabling, it is not desireable to significantly reconfigure the setup.PC has PXI-8362 module controlling PXI1 and PXI3PXI1 connected to PC via PXI-8360 SCXI-1001 connected to PXI1 using PXI6040E controller TC Modules SCXI-1000 daisy channed to PXI1 (6040E controller) TC Modules SCXI-1001 connected to PXI3 via PXI6040E 1163R Relay modules PXI2 connected to PXI1 via MXI cable Multiplexer modulesThanks in advance for your help,Adam

Multifunction DAQ

SCXI-1001Does not Read properly

Hi Adam,

It appears that you have done quite a bit of troubleshooting on this particular chassis. If you have already followed the steps in the Troubleshooting SCXI Chassis KB, replaced the 1346, fuse and cables and verified that the problem stems from the chassis then my suggestion is that you send it into NI for repair.