CPX Festo Ethernet/IP - Labview

[isaias308123]

I'm trying to set up connection between PC and Festo CPX-FB36 (with Ethernet/IP)

I linked the module via MODBUS TCP , and it worked correctly all the outputs and valves were activated.

For Ethernet /IP it is configured as follows .

 CPX-FMT configuration

with this the communication is established, now all that is missing is the sending of data, to activate outputs and valves.

does anybody have any suggestions?

[zaki_Khan]

hello ,

are you find a solution ?

because i have the same situation and  i dont know how can i use CPX Festo with LV,

thanks

[isaias308123]

Yes i finding to solution with modbus tcp and ethernet /ip

[zaki_Khan]

please can you give me a project or tutorial how can i use it because i'm beginner in labview and i dont know how to use it , thanks

[Carsten_1412]

is it possible to send this VI to me? would appreciate it.

[isaias308123]

good day

I can send you the VI file, I have also done it with SMC interfaces, it is quite easy, and also with Ethernet/IP SMC, FESTO, Mitsubishi controllers, etc, they have to be with Ethernet/ip protocol.

best regards

[Carsten_1412]

can you post it here or do you prefer my email?

[Ali_D]

Hi, 

Can you post your solution (or VI) here? I have a similar issue so it might help me, and others in the future, too. 

Thank you!

[isaias308123]

hello, the only problem I had when developing the project is the attribute and the class, this is focused on ethernet/ip CIP so it was not in the manual.

best regards

you can send me an email

imartinez@integracionid4.com

[Perelli]

Can you please send also to my address the solution?

perelliraffa@yahoo.it

Thanks