How to access the columns of measurement, low limit, ... in the report in my sequence

[to0bi]

Hi everyone,

I created a little testsequence of a HDD-check as you can see:

Now i was just wondering how to access the columns of measurement, low limit and high limit in the upper box, so that i only need one box for this sequence and don't "waste" so much place on my report.

The lower box is created with the "Numeric Limit Test"-function.

Is there any setting in my sequence, where i can access these things?

 

[Oli_Wachno · Accepted solution]

Hi Tobi,

no possibility to configure this in your sequence or step settings.

The graphical representation (rows an coloums you are referring to) are created by using a stylesheet on the raw xml data, which is actually created.

You can modify the stylesheets though.

https://www.ni.com/docs/en-US/bundle/teststand/page/generating-and-customizing-teststand-reports.htm... is a good starting point