TestStand can't find vi

[jvh75021]

After installing SP1 on LabView 2009 I tried to run a sequence that worked b4 the update from the sequence editor and TS reports it can't find the VI. The VI is where it has always been. I get a runtime error but no option to find the VI. How do I help TS find it? The VI in question is several calls deep.

Thanks,

jvh 

[Mark_Ireton]

Are you using relative paths to specify the VI file?  If so, check your TestStand search directories to make sure they include the location of the VI.

[jvh75021]

That's a good question, Mark. I inherited this thing and being new at TS and LV I am not aware of how the addressing mode is specified.

Turns out my immediate problem was caused when the .tsw file was modified during a remote login troubleshooting session.

jvh