I am attempting to send a specific number of square pulses on my AWG, but I can't seem to find the correct way to accomplish it.
Ideally, I'm trying to avoid using timing to control the number of pulses, if there is a way I can setup my code to tell the AWG to fire out 10 square pulses at a specific frequency and then stop, that would be the best solution.
Something I did try was to create a digital waveform with the correct number of pulses, but it seems that the AWG does not accept digital waveforms as an input.
If anyone has some guidance on how to proceed with setting this up it would be greatly appreciated.
I am using LabVIEW 2019.
