Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

[HoomanGh]

Dear all,

I am very new to Labview programming. I try to simulate a two-level three-phase VSC using Multisim co-simulation with Labview. I modeled the plant and control system in Multisim and Labview, respectively. However, when I want to run te model I get the following error! 

Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

Possible reason(s):

Control Design and Simulation: The shared library corresponding to the external model returned an error.

Launching Multisim was unsuccessful. (L404)

I would be very grateful if you could address this error! Thanks for your time!

[r_sunyak]

Hi,

If you could share with us the whole project, it would be easier to help you.

If it is not possible from your side, we can discuss some details via email.

kind regards,

$

[Abusamra]

---

@HoomanGh wrote:

Dear all,

I am very new to Labview programming. I try to simulate a two-level three-phase VSC using Multisim co-simulation with Labview. I modeled the plant and control system in Multisim and Labview, respectively. However, when I want to run te model I get the following error! 

Error -2367 occurred at External Model in VSC_Control.vi/Control & Simulation Loop

Possible reason(s):

Control Design and Simulation: The shared library corresponding to the external model returned an error.

Launching Multisim was unsuccessful. (L404)

I would be very grateful if you could address this error! Thanks for your time!

---