I am getting this error whenever I try to start taking a measurement in NI MAX for my NI 9862 module. I added a 120 Ohm resistance according to the pin allocation in the documentation and I have an external power connected with the module so I am not sure where the problem lies.
I took pictures of my connections and attached them to my post. The external power is coming from the board and I added a 110+11 Ohm resistors to the socket.
Hi, did you manage to solve this issue? I have my NI-9862 card connected to cDAQ-9185 which is plugged to 230V socket. Voltage is then reduced to 12V, within the specified range for both cDAQ and NI card. I'm currently stuck on the same error.
