USRP Software Radio

cancel
Showing results for 
Search instead for 
Did you mean: 

USRP-2920 flash update problem, bricked, Your device does not correctly report its version information

Hi,

I have several pcs of USRP-2920, but 2 pcs of the same age can not be flashed.

In normal run it does not react in any way. Only status LEDs starts up.

In safe mode (S2 button) I can see it in configuration utility, but it is impossible to change the IP or update the images.

When updating the FW and FPGA, there is the omnious warning:

 

Your device does not correctly report its version information. It is possible to damage a device with the incorrect FPGA image revision. Please ensure that you are using the correct image version for your hardware by checking the sticker on the back of the device (e.g. r:2.0 implies that you should use the r2 image file). Press OK to proceed or Cancel to abort.

 

It finishes the update procedure, but nothing changes.

It seems to be a firmware problem.

Does anyone have a solution?

 

Thanks a lot.

 

Martin

VSB Technical University Ostrava

Neo
Hardware-designer, inventor, freak...
FEI, VSB Technical University Ostrava
0 Kudos
Message 1 of 2
(884 Views)

Is this a copy of other forum thread? These 2 threads were created parallelly. 

0 Kudos
Message 2 of 2
(842 Views)