LabVIEW G-code Sender

[おおはし]

Hello,

Sorry for the confusing post.

Download “lvGS_demo.zip 154 KB” in the third message (10-09-2017 03:56 AM) of this post.

[sdmi1379]

Hello 

I want to use this project. To control X, Y and Z axis, but only for X axis, the G-Code program works, for other axes like Z, the motor rotates at uncontrollable speed. I used the DVD-DRIVER engine. Please guide me for this.

[おおはし]

Hello sdmi1379,

Your device has a problem where you can control the X-axis but not the Z-axis.

The G-code Sender only sends a string of G-code, so if the X-axis works properly, the G-code Sender is probably normal.

I think you are using the GRBL software, but I think you should consider whether the version is appropriate. In the photo of the board you attached, it looks like you are using a slightly old CNC shield V3.0. The latest version of GRBL is ver1.1, but the board you are using is old, so I think it would be better to check the operation using ver0.8 that matches the board.

Also, the motor driver board used for the Z-axis may be broken, so swapping the X-axis board and the Z-axis board will help isolate the cause.

I hope this information is helpful.