DCAF Editor Executable - failed to deploy configuration

[MaximeR]

Hello,

I have build an executable of the editor. I can edit my configuration without problem on my target computer using only the Run-time engine of LabVIEW.

When I tried to deploy the configuration on my cRIO, I have this error :

Failed to deploy file with error :

ssh_init : Network error : Cannot assign requested address

I've got an error before, this was because Putty was not installed. First I download and Putty x64, I just tried with the 32bits version of Putty after restart my computer I still have this issue (Putty 0.74).

It's working well in source and with executable on my development computer (Putty 0.64 installed by DCAF pcakge installation).

Do I need to set something specific to get it work ?

thanks for your help.

[MaximeR · Accepted solution]

I found the solution. It was the putty version. i installed 0.64 32 bits and it's working. In this case. it was just needed to add Putty path installation inside windows Path to make it works.

Best regards