Hi,Just began playing with cRIO (and already running into problems!). I have a cRIO-9004 controller with some IO modules. I am basically following the instrcutions from the following manual:http://www.ni.com/pdf/manuals/371012d.pdfWhen I run the VI, it starts to compile, and appears to compile successfully as well (because the Compile Server gives a status of 'Compile Completed'), however, immediately after this I get the "Target Specific Error Encountered" with error code -63195 as shown below: Why would this be happening? Any input will be appreciated.Thank you and regards,Khalid Message Edited by Khalid on 11-07-2006 10:06 PM

I should have updated the resolution here: Apparently, if we have the "Autolmatically close VISA sessions" LabVIEW environment setting enabled, we get this error. Disabling this solved my problem. I no longer get the -63195. I am hoping NI will either fix this, or document this somewhere. Regards, -Khalid

FieldPoint Family

cRIO Target Error -63195

Solved!

I have the same problem, have you solve this now?

Message 11 of 14

(2,497 Views)

Author

Please read the earlier replies for the solution.

Regards,

-Khalid

Message 12 of 14

(2,493 Views)

I tried the solution that you did, but it did not work, have you any other method?

Message 13 of 14

(2,438 Views)

Hi zhixin,

Please refer to the following document regarding your error: https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z0000019MITSA2. If you already unchecked the Automatically Close VISA Sessions checkbox, try out the change to the LabVIEW.ini file described.

Brian.D
NI Product Owner
VeriStand