How can I control Brooks GF 100 Thermal Mass Flow controller via LabView

[zahir_usa]

Hello folks,

I have a Thermal Mass Flow controller from Brooks Instruments (GF100). I got a RS232 to RS 485 converter and cable for connect through diagnostic port of MFC. But I haven't got any driver or specifications for connecting to labview. 

I am very new in Labview and seeking proper instructions to control it via labview.

Thanks

[nyc_(is_out_of_here)]

This kind of question just makes my eyes glaze over because it is too overly broad.

If you don't know anything about LabVIEW start with the online tutorials and the examples included.

[nyc_(is_out_of_here)]

---

@davekorpi wrote:

Happy to help...

See if you can get some freebie advice here first and if nothing than you may want to pop me an email at dave.korpi@gmail.com and I can hook you up but I will charge a bit for it because it is a bit of a job.

Dave

---

It is against the Terms of Use   to solicit business. You might want to re-read it.

[Rohama_K]

Here are the links from davekorpi's post:

http://www.brooksinstrument.com/documentation-a-downloads/viewcategory/144-labview-drivers.html

http://www.brooksinstrument.com/documentation-a-downloads/viewcategory/44-digital-communications.htm...

[zahir_usa]

Thanks a lot everyone. Appreciate it.