running function generator (HP 33120) at higher than 1KHz by Labview

[faheemkhan]

Dear all

To run a function generator HP 33120 by Labview, I downloaded a driver "Agilent 33XXX Series", also attached with this message. But the vi files (e.g. "Standard Waveform.vi" or "Arbitrary Waveform.vi" ) available in this driver, dont allow the function generator to generat a signal of more than 1 kHz, while I need about 200 kHz. Manually the function generator can easily generate a signal of 15 MHz.

So I need a driver/vi of this function generator which can make it generate a signal at about 200 kHz. Kindly help me.

Thanks in advanced

Regards

Faheem

[Dennis_Knutson]

The driver does allow you to set any frequency. What makes you think you cannot?

[faheemkhan · Accepted solution]

Dear Dennis

I think I had hardware problem where I was able to change frequency from 1000Hz to 999Hz and so one but I was unable to increase from 1000Hz to 1001hz and so on. But now it is solved.

Thanks again