Can't use third party simulation mode in PXIe-786xR

[rafiqa]

I want to simulate PXIe-786xR with xilinx (vivado 2015.4). But the third party simulation mode can't be selected...

What must i do?

[GatorChomp · Accepted solution]

Hi rafiqa,

If you haven't, I'd recommend posting this question in the normal LabVIEW discussion forums rather than here. This forum is for the LabVIEW Communications System Design Suite which is a LabVIEW NXG Suite. The workflows in that software are different from LabVIEW FPGA.

That being said, this document should be somewhat helpful: Cycle-Accurate Simulation with Xilinx ISim. Two comments:
1. You should choose the Xilinx Simulator instead of ISim in the LabVIEW Options, but I think most of the instructions remain the same.

2. You will need to have the LabVIEW FPGA Xilinx Compilation Tools installed locally for this to work.

[rafiqa]

Thanks for the information...