CRIO9074-FPGA Error

[btncan]

Hello everyone,

I work with CRIO9074 and transfer the project I developed on the microcontroller side to the FPGA side.

Although I compile and run my project on the FPGA side, I started to get a new error and now I cannot compile and run the fpga program.

I tried again by creating a new project but it did not work again.

I don't understand what this error is caused by, because the working system started to stop working.

Below is the error screen, can you help?

[GerdW · Accepted solution]

Hi btncan,

just do what the message says!

You are changing from Scan engine to FPGA mode, and you need to apply the correct settings...